Replace the BR-1800 Printer Print Head

1. Move the Carriage Unit to the center and remove the ink damper.
2. Release the Print Head FFC Guide from the three Tabs to remove the FFC Guide from the Carriage Unit.

3. Remove the three C.B.P. M2.6 x 8 screws that secure the Print Head using No.1 Phillips Screw Driver, and vertically lift the Print Head to remove.

4. Remove the two Head FFCs from the Print Head.

5. Reinstalling the Print Head
The screws must be tightened. while the Print Head is held down in the direction of the arrow.

Note:
Make sure that the Pad is attached at the position

The Print Head must be installed with the Guide Pins of the Carriage Unit aligned with the positioning holes on the Print Head.