How to set the position with brotherjet RIP when we printing

Now, Please follow me!
if you use the card/CD/pen/golf or ther jig
We ake card jig for example.
1. We can find the “XY Starting Point” file in the CD.

2. Input the “XY Starting Point” to the BROTHERJET RIP software.

3. Covering the working table with paper, then we can print. “XY Starting point” file.

4. Imput the artwork into the Brotherjet RIP.

5. Clean the surface of cards by napkin dip alcohol. Spary coating on cards evenly and dry them for 5 minutes (not too long).

6. Put your card tray on flatbed according to X,Y lines and use your double-side tape to fasten. Make sure it does not move during printing.

7. Setting the Brotherjet RIP software.

8. Press “up” move flatbed until it stops itselft.
We set printing distance between object and print head to 5mm.
There is a infrared ray go through, if any object obstruct it. The red light will on and cut off the motor which move the flatbed.
The press “down” until the red light off.

9. Everthing is ok! We can print it.

If you don’t use the card\CD\PEN\Golf or other jig, we take one card for example.

1. Print the “XY Starting Point” file as above.

2. Make the card size: width=8.5cm, height=5.4cm

3. Imput the artwork into ther Brotherjet RIP and set the parameter.

4. Put the card on the workingtable. Make sure it does not move during printing.

5. Press “up” move flatbed.
We set printing distance between object and print head to 5mm.

6. Press “back” home and then print.