How to put the ink into the printer?

1. Ink filling.

Filling ink into the ink bottles.
1) Open the printer cover and press INK button on the control panel ,then the head will leave it’s home position from the right side to left about 3cm.Wait until the head stops moving. Then move the head to the middle of the working table.

2) Then take out the ink bottles from the Ink stock.

3) Take out all the rubber holders from the ink bottles.

4) Suck the inks fro the ink bottles into the syringe, and then fill the ink into the ink bottles through the holes. Each syringe is for each color. Keep filling inks until the ink levels reaches around 50% of the capacity of each ink bottle.

5) Put the rubber holders into the ink bottles again
19

6) Finish.

2.Ink following:

We have put all color ink into the ink bottle ,but the CISS ink system still can’t be used, we need to make the whole ink system filling ink.

1) Take out the Cartridges

2) Connect the Syringe to Cartridges. Notice:

A: Put the connector of the syringe totally into the cartridge hole until we can not put inside more.
B: The syringes can not be mixed for colors. Each syringe is for each color.
C:We should keep sucking until we can some inks into the syringe a little.

3) Put the Cartridges back to the carriage and try to press the front of the cartridges as showed in the next picture until we can hear CLICK sound from each cartridges.

4) Move the head manually by hands to its home position(In the right side of the machine).

5) Please find another syringe and the soft tube about 20cm included in the tool package. Connect the soft tube to the syringe.

Then connect the other end of the tube to the waste ink tubes. Try to suck the syringe until some ink come down into the waste ink tank lines. We will need to make the same operation for two waste ink lines in BR1900 .

6) Ink system installation was done.