Errors appeared during the starting( power on) for BR-1900

1. When starting the printer, the platform doesn’t move outward and the error LED in the control panel doesn’t glow neither. Start is normal, but the computer points out the paper entering model is wrong after sending order.

When starting, the printer enters roll paper mode, try to restart the printer

2. When starting, the ink changing reminder Light glow which on the control panel, there is a small piece of circuit board on the machine frame that opposite the initial position of carriage unit, the light will bright which with ink cartridge color code. After sending the printing order, Computer points out that the installation of print cartriage can’t be identified or is wrong.

First please press Ink Change Button and after cartridge moving out of the previous position, then please press the reset button on the ink cartridge that corresponding to the lighting color, pressing about 2-3 seconds.Then press the ink change button again, the phenomenon could be excluded after the carriage unit return.

If the above operation still can’t solve the problem, please press the ink change button, take out the ink cartridage and reset it totally after the carriage unit walk out the initial position, press the ink change button again it will be ok when the carriage unit return.

Restart the printer after taking out the ink cartridge.The ink out director light will bright then press the ink change button, install the ink cartridge back after the carriage unit walk out the initial position.Then press the ink change button let the carriage unit return.

3. When starting, the platform moves out totally. Ink Changing Reminder Light  and Product Placement Light   of control panel are normally on. The Computer points out generally error:

Before starting the online switch, the platform doesn’t enter in place(move back to the last place). Please press the enter button, making the platform entering totally then restart the printer.

Please turn off the printer and delete the not printed files in the computer, then restart the printer.

Please use the clean bathroom tissue to wipe the raster strip and round raster slice in the side of the motor where paper throw then restart the printer.

4. After starting, Ink Changing Reminder Light  and Product Placement Light of control panel flashing alternatively. After sending the order, computer points out some fittings of this printer are overdue.

The data of ink-jet numeration that controlled by printer has fulled, which is needed to clear the data. Please contact the technicians of our company.

5.When starting, the platform moving forward quickly and irregularly, after the carriage unit moving several times, the ink change reminder light and product indicator light normally on, the computer points out general error:

The raster encoding disk is dirt, please use the clean bathroom tissue wipe the whole edge of the raster slice.

The place of raster encoding disk and the opposite sensor combination is deviated, please adjust the mutual counterpoint of raster encoding disk and the opposite sensor combination until find the suitable corresponding point.

The five core round cable of sensor on the raster encoding disk is poor connected or cracked. Please reconnect or change the round cable.

6. After turning off the main power, the light on the main power doesn’t bright, the printer lie in no power supply situation:
Please check whether periphery power socket board has power supply, whether the power line is cracked, whether the protective tube of the power incoming line socket is burned down on the back side of printer.

7.After turn off the main power, the power press key light is bright. After starting the online switch, the key-press panel doesn’t have any demonstration:

Please check whether the connecting round cable in the back of the press key
panle is loose.

Please check whether the connecting compressed round cable between the printer
main board and square pinboard is disconnected or loosed.

The main board of printer is damaged.

8. When starting the printer, after the carriage unit moved and returned, in the process of self-check ink pumping, the cleaning pump unit will click, then ink change reminder light and product placement indicator light normally on, the computer report general error;

Please clean the spindle under the screed of pump unit, the discarded ink that accumulate will hinder the proper motion of turning gears or add resistance result in the click phenomenon.

Please clean the raster strip and the sensor of raster strip.

The cleaning unit is damaged, please change the cleaning unit.